A.M.P.I. Master-8 Manual de usuario descargar pdf (Pagina 10)

9. Triggering

9.1 Manual Triggering

In the TRAIN, TRIG or DC modes you can trigger the channel manually.

Example 1 : When channel 3 is in the TRAIN mode, every key stroke on the ‘3’ key evokes a train of

pulses according to the parameters of channel 3.

Example 2 : When channel 4 is in the DC mode, every even key stroke on the ‘4’ key turns the channel

on and every odd key stroke turns it off.

When a channel is not in one of the above modes, or if it has already received a trigger but has not yet

completed its response, pressing the channel number does not affect the channel (it just clears the

display).

9.2 Setting the internal connections:

In the TRAIN or TRIG modes, you can trigger the channel by other channels internally. Each channel

has an internal input and an internal output. By inserting the right instructions, you can connect an

internal input to an internal output.

Example 1 : In order to connect the output of channel 2 to the input of channel 3 -

Press keys: ‘CONNECT,2,3,ENTER’.

Note that the arrow on the front panel above the display shows the direction of the connection. For

example, 2,3 means that the output of channel 2 is connected to the input of channel 3. Every internal

output can be connected to any number of internal inputs. Every internal input can be connected to any

number of internal outputs. The level or polarity of the output does not affect the internal connections.

To disconnect press the ‘CONNECT’ key twice.

1 - Introduction

file:///D|/users/benny/master8.htm (10 of 14) [07/04/2002 12:32:07]

1 2 ... 5 6 7 8 9 10 11 12 13 14

Sin comentarios

A.M.P.I. Master-8 Manual de usuario Pagina 10